Installing The Belt Clip - Uniden DWX207 User Manual

5)
Insert the bottom end of
the cover into the grooves
on the handset and lay
the cover over the battery
compartment. Tighten the
four screws securely.
Notes: • If there is any foreign
matter on the rubber seal
located on the under side
of the battery cover, the
handset may not be
water tight.
• The rubber seal should
be replaced every two
years, even if it does not
look worn.

Installing the Belt Clip

Insert the tabs on the sides of the belt clip
into the holes on either side of the handset.
Press the belt clip down until it clicks into
place. (Tug on the clip to make sure it's
secure.)
To remove the belt clip, gently pull the tabs
out of the holes, then slide the belt clip off
of the handset.
8