Remove The Upper Case (With Keyboard And Touchpad); Disassemble The Lcd Module - Lenovo Legion 5 Series Hardware Maintenance Manual

Figure 34. Remove the LCD module

Remove the upper case (with keyboard and touchpad)

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the battery pack" on page 29
"Remove the solid-state drive (SSD) plate" on page 30
"Remove the solid-state drive (SSD)" on page 30
"Remove the solid-state drive (SSD) stand off" on page 31
"Remove the Wi-Fi card" on page 32
"Remove the hard disk drive (HDD) module" on page 32
"Remove the memory module" on page 33
"Remove the heat sink" on page 34
"Remove the fan" on page 35
"Remove the I/O board" on page 36
"Remove the Kensington lock bracket" on page 37
"Remove the DC-in bracket" on page 37
"Remove the RTC battery" on page 38
"Remove the speakers" on page 38
"Remove the system board and the I/O board cable" on page 39
"Remove the power board module" on page 42
"Remove the strip cover" on page 42
"Remove the LCD module" on page 43
Go to
https://support.lenovo.com/partslookup
part:
Upper case (with keyboard and touchpad)

Disassemble the LCD module

The LCD module as a whole is not an FRU. Instead, it contains FRUs as its components. Before
disassembling the LCD module, make sure it has been detached from the upper case.
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
45