Remove The Kensington Lock Bracket; Remove The Dc-In Bracket - Lenovo Legion 5 Series Hardware Maintenance Manual

Go to
https://support.lenovo.com/partslookup
part:
I/O board

Remove the Kensington lock bracket

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the Kensington lock bracket.
Figure 18. Remove the Kensington lock bracket
Screw specifications
M2 x L7
Go to
https://support.lenovo.com/partslookup
part:
Kensington lock bracket

Remove the DC-in bracket

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the DC-in bracket.
to look up the Lenovo part number of the following replacement
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
37