Register The Handset - Uniden DCT5260 Owner's Manual

3) Install the new batteries supplied with your phone. Check for correct polarity
(see page 13).
"
4) Replace the battery cover by sliding it upward.
5) Place the handset in the charging cradle, and allow it to charge for 17-20 hours.
While charging the batteries, all the handset keys will be disabled.

Register the Handset

If you purchase an extra handset, you need to register the handset before use.
Only one handset can be registered at a time.
The handset ID for the supplied handset(s) was assigned at the factory, which has
#1 (#1 and #2 for DCT5260-2) in the display. When you register additional handset
to the base, the handset ID will be assigned.
An extra handset can be registered when the base is in the standby mode.
1) After charging the handset, remove the handset from the charger and place it in
the base.
2) Registration starts automatically.
While registering, "
3) When the registration is complete, "
the display.
If the registration fails, "
steps above again.
" appears in the display.
" appears in the display.
" appears in
" appears in the display. Try the
E X PA N D I N G Y O U R P H O N E [ 47 ]