Using The Caller Id Message List - Uniden DCT5260 Owner's Manual

• You cannot make a call
from the Caller ID list
if your phone is
connected to a private
branch exchange (PBX).
• When a long distance
call has been set, " "
appears in the display.
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information
is stored.
• If the Caller ID
message was received
as a private/unknown
number, or the
message does not have
the number, you
cannot store the
message in the
Phonebook. Or it was
received as
private/unknown name,
the message will be
stored as <No Name>.
• Even if the 100
memory locations are
full, the message will
be stored in the
Phonebook. However,
the message will be
erased from the Caller
ID list.
[ 44 ] C A L L E R I D

Using the Caller ID Message List

Calling a party from the Caller ID list
From Standby mode
1) When the phone is in the standby mode, view the Caller
ID message (see "Viewing the Caller ID List" on page 42).
2) Press talk/flash or speaker. The displayed phone
number dials automatically.
From Talk mode
1) Press talk/flash or speaker.
2) View the Caller ID message you want to dial (see "Viewing the Caller ID List"
on page 42).
3) Press the DIAL soft key. The displayed phone number will be dialed.
Long Distance calls and Area Code Setting/Cancellation
While the present Caller ID information is displayed, pressing
remove the prefix " " in the display to set the call for a long distance call, or pressing
# will set or cancel an area code (see page 24).
/ s
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook. The phone number
and name of the party on the Caller ID list can be stored in memory.
1) When the phone is in the standby mode, view the Caller ID message to be stored.
Then press the STORE soft key. "
2) To complete the setting, follow the steps 5-9 in " Storing Phone Numbers, Names,
Distinctive Rings, and Speed dial" on page 34.
/tone/ t will place or
" appears.