Setting Up The Menu - Uniden DCT5260 Owner's Manual

For Deregister HS,
make sure the line
is not in use, and
the handsets are

Setting up the Menu

within the range
limits of the base.
[ 20 ] G E T T I N G S T A R T E D
System Reset
This menu is used to clear the handset ID from the base, or the base ID from the handset.
Submenu name
Deregister HS Clear the handset ID from the base. Use this menu, for example when
you change the digital security code (see page 25).
Replacing Base Clear the base ID. Use this menu, for example, if you replace the base with a different
base of the DCT series model (DCT5260/DCT5280/DCT5285 series) (see page 25).
Entering the Menu
1) Press the MENU soft key in the standby mode.
L M
2) Use volume/ or
main menu (DirectLink Mode, Handset Setup, Global
Setup, and System Reset).
3) Press the OK soft key to enter the menu. To return to
the previous screen, press the BACK soft key.
L M
4) Use volume/ or
then press the OK soft key to enter.
In the submenu, volume/
confirm your selection. To return to the previous screen, press the BACK soft key. For
detailed instructions, see the following sections for the desired submenu.
5) To exit the menu, press the end key.
• If any of the following occurs during the menu operation, the operation will be cancelled.
- Press the end key.
- Press talk/flash or speaker.
- Charge the handset.
- Receive an outside/intercom call or page.
• If the handset remains idle for 30 seconds, the phone will return to the standby mode.
Description
to move the pointer to a desired
to select a desired submenu,
L M
or is used to select an item. Press the OK soft key to