IS0232
Calibrating the
Sensor
Adjusting the Sensor
Time Delay
6
5.
On the amplifier box, if the sensor light is amber, carefully turn the
screw counter clockwise until the light changes to green and
subsequently back to amber.
6.
Remove some adhesive so that the adhesive level is below the
sensor and ensure that the sensor light changes to green.
CAUTION!
CAUTION!
CAUTION!
CAUTION!
CAUTION!
Periodically check the level of adhesive to ensure the
sensor is working properly.
7.
Reinsert the protective screw back into the amplifier box.
8.
Close the front operator panel.
1.
Go to the setting screen by pressing
2.
Unlock the control by using the level 3 password "6550".
3.
Go to the setting screen by pressing
4.
Go to the "System" screen.
Internal Level Sensor Instructions
.
again.
Valco Melton