VALCO MELTON D10 Manual page 264

D AND S SERIES PUMP CHANGE PROCEDURE
4 / 1 3 4 / 1 3 4 / 1 3 4 / 1 3 4 / 1 3
Important
Information: Read
Before Use
Before Replacing
the Pump
Shut-off Plug
Valco Melton
Warning! Warning! Warning! Warning! Warning! Read and follow all instructions, warnings, tags, and
labels before operating the equipment. Only qualified
personnel should perform this procedure. USE OF THIS
EQUIPMENT IN A MANNER OTHER THAN
DESCRIBED IN THIS INSTRUCTION SHEET AND
FAILING TO FOLLOW ALL INSTRUCTIONS COULD
RESULT IN PERSONAL INJURY, DEATH, OR
DAMAGE TO EQUIPMENT.
Warning! Warning! Warning! Warning! Warning! All equipment is to be installed and all connections are
to be made ONLY by qualified personnel. Components
and accessories are to be installed in accordance with
the instructions provided and applicable codes for the
region installed. Failure TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN PERSONAL
INJURY, DEATH, OR DAMAGE TO EQUIPMENT.
Caution! Caution!
Caution! Caution! Caution! The instructions and guidelines in this instruction sheet
are general guidelines. Always follow the manufacturer's
documentation and instructions for each part of the
system such as the valve, the solenoid, the application
mechanism, etc. Failure TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN DAMAGE TO
EQUIPMENT.
If changing the pump in a D4 Unit, the tank must be drained before
proceeding, to prevent glue leakage.
If changing the pump in a D10 or D16 Unit, it is not necessary to drain the tank.
These units include a tank-connection shut-off plug that can be opened or
closed, using a screwdriver (see below). Turn the plug to CLOSED (slot to
horizontal position).
Plug slot vertical (as shown): Plug slot vertical (as shown): Plug slot vertical (as shown):
Plug slot vertical (as shown): Plug slot vertical (as shown):
Tank valve is OPEN.
Plug slot horizontal: Tank valve Plug slot horizontal: Plug slot horizontal:
Plug slot horizontal: Plug slot horizontal:
is CLOSED.
IS0212
1