Therefore, this fan is equipped with a wattage limiting device. Installation Guide For Model: Table of Contents: E-FR52ABZ5CR Safety Tips. pg. 1 Unpacking Your Fan. pg. 2 Parts Inventory. pg. 2 Installation Preparation. pg. 3 Hanging Bracket Installation. pg. 3 Fan Assembly.
SAFETY TIPS. WARNING: To reduce the risk of electrical shock, turn off the electricity to the fan at the main fuse box or circuit panel before you begin the fan installation or before servicing the fan or installing accessories. Read all instructions and safety information carefully before installing your fan and save these instructions. CAUTION: To avoid personal injury, the use of gloves may be necessary while handling fan parts with sharp edges.
1. Unpacking Your Fan. Carefully open the packaging. Remove items from Styrofoam inserts. Remove motor housing and place on carpet or Styrofoam to avoid damage to finish. Do not discard fan carton or Styrofoam inserts should this fan need to be returned for repairs.
3. Installation Preparation. blade edge To prevent personal injury and damage, ensure that the hanging location allows the blades a inches 7 feet (2.13m) (76 cm) clearance of 7ft. (2.13m) from the floor and 30in. (76cm) from any wall or obstruction. This fan is suitable for room sizes up to 400 12ft.
Page 5
5. Fan Assembly (with downrod). If you wish to extend the hanging length of your set screw hole set screw fan, you must remove the hanging ball from the 6in. downrod provided to use with an extended stop pin downrod (sold separately). [If you wish to use the 6in.
5. Fan Assembly (with downrod). (cont.) With the hanging bracket secured to the outlet box and able to support the fan, you are now ready to hang your fan. Grab the fan firmly with two hands. Slide downrod through opening in hanging bracket and let hanging ball rest on the hanging hanging bracket tab bracket.
remote control transmitter 7. Wiring. code switches Use a ballpoint pen or a small screwdriver to set the code switches for the remote control transmitter and remote control receiver so that they match. Factory setting is pre-set and not recommended for use. If your remote control interferes with other appliances, change to another matching code on the remote control transmitter and receiver.
9. Blade Assembly. motor housing Time Saver: Washers for blade screws can be set on each blade screw prior to installing blades. Locate 15 blade attachment screws and washers in plastic one of the hardware packs. Hold blade arm up to motor blade and align holes.
Page 10
10. Light Kit Assembly (Optional). (cont.) Align hole in center of glass shade with threaded motor housing rod on light kit fitter and gently push up on glass shade. Secure glass shade with finial that was previously removed. NOTE: Do not overtighten finial as glass may crack switch housing or break.
11. Remote Control Operation. light dimmer setting LIGHT button - Tap once to turn light ON or OFF. Liquid crystal display shows the amount of fan setting brightness as a percentage. Holding the button down for more than 2 seconds will cycle light through brightness settings.
Troubleshooting. Warranty. LITEX LIFETIME LIMITED WARRANTY: LITEX INDUSTRIES, LTD. warrants this fan to the original household purchaser for indoor use under the following provisions: 1-YEAR WARRANTY: LITEX INDUSTRIES, LTD. will replace or Problem: Fan fails to operate. repair any fan which has faulty performance due to a Solutions: defect in material or workmanship.