Mitsubishi PLK-E1008H Technical Manual page 18

(b) Press the [wind mode key](NO. ).
(c) Then wind mode window will be
appeared.
Pass through the thread from thread stand as shown on the figure then, wind the thread
(3)
to the empty bobbin(NO. ) in the arrow mark "A" direction couple times, and insert the
bobbin winder.
(4) Push the adjust lever (NO. ) in the arrow mark "B" direction.
(5) Down the work holder with black color work holder foot switch.
(6) Step on the gray color start foot switch.
The thread is kept winding to the bobbin (NO. ) while the gray color start switch is stepping on.
With programming, the bobbin winder can be kept winding with only once stepping on
NOTE
the start switch.
(7) After finished the bobbin winding, the adjust lever (NO. ) is returned to the original position and
the bobbin winder is stopped automatically.
Under the setting for the bobbin (NO. ) to be kept winding with continuously stepping
NOTE
on the start switch, the sewing machine is kept running idle even the bobbin winding is
finished unless the start switch is released.
Please make sure to release the start switch after finished the bobbin winding so that the
sewing machine can stop running idle simultaneously.
After winding is finished, press [X] key (NO. ) to go back standard mode
(8)
(9) To wind the bobbin thread during the sewing operation, carry out above (3) and (4) procedure
then, the bobbin winding is performed automatically.
(10) Regarding the adjustment for the bobbin thread winding volume, please refer to the instructions
in the paragraph 7-11 Adjustment of the bobbin winder in the following page.
②
⑥
13