Advertisement
ALLEGRO® REFORMER (PURCHASED AFTER 6/21/07)
STANDARD JUMPBOARD
To install the standard jumpboard on your Allegro or Allegro
Stretch, set up the trunnions based upon which model of
reformer you have:
1. Slide footbar into position depending on your model: For
Allegro: Move to Second Rail positions, from carriage (See Figure
F) For Allegro Stretch: Move to Third Rail positions, from carriage
(See Figure G) 2. Adjust footbar on trunnion depending on your
model: For Allegro: Second from the Top position (See Figure F)
For Allegro Stretch: Third from the Top position (See Figure G)
Second position
from stopper.
Second from
top vertical
position.
Figure F
Figure G
3. Next, attach the jumpboard by inserting the flange on the
jumpboard into the jumpboard clip (Figure G). The backside of
the jumpboard should be resting against the footbar.
Allegro jumpboard
(backside)
Figure G Cross section of proper jumpboard installation
2
Stopper
Anti-wear strip
and standing
platform edge
Lower
Flange
Jumpboard
clip
If there is a gap between the
jumpboard and the footbar, a
grey strip of foam is included
that can be installed on the
back of the jumpboard to fill
the space (Figure I).
ALLEGRO® REFORMER (PURCHASED BEFORE 6/21/07)
STANDARD JUMPBOARD
First, adjust the footbar horizontally to the second hole from the
carriage. Next, adjust the footbar vertically so that the pins are in
the second hole from the top.
Insert the tapered end of the
jumpboard in front of the
footbar so it rests in the slot
behind the standing platform.
The back of the jumpboard
should be resting against the
footbar (Figure J).
Arrange the elastic cords so that both hooks hang over the top
of the footbar. Hook one end of the cord into the top hole of the
transport wheel bracket. Next, grab the cord firmly at a position
between the chrome eye straps and pull it toward the unhooked
side (Figure K).
This will create enough slack to allow hooking into the other
transport wheel bracket. Before using, check that all footbar
positioning pins are properly engaged and that both cord hooks
are secure (Figure J).
Figure K
Figure I
Figure J
Advertisement
