Reinstallation Of Shipping Materials - Speed Queen SF3JM Installation & Operation Manual

Maintenance
1. Pump

Reinstallation of Shipping Materials

To prevent damage while moving the unit, the shipping materials
MUST be reinstalled.
1. Disconnect washer from electrical supply.
2. Remove two screws at bottom of front access panel.
3. Rotate bottom of panel out and remove panel.
4. Attach shipping brace to weight and base using four bolts and
washers. Refer to Figure 22 .
5. Reinstall front access panel.
6. Go to rear of washer to install rear shipping bolt, washer,
spacer assemblies.
7. Insert shipping bolt assemblies into each shipping bolt hole.
Refer to Figure 23 .
8. Tighten bolt while pressing washer against rear panel to en-
sure spacer is fully inserted.
1. Shipping Brace
Figure 22
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
1
FLW2444N_SVG2
1
FLW2296N_SVG
1. Shipping Bolt Assembly
24
1
FLW2297N_SVG
Figure 23
Part No. 805197ENR6