Reinstallation Of Shipping Materials; Cleaning Foreign Object Trap - Speed Queen frontload washer User Manual

Reinstallation of Shipping
Materials
To prevent damage while moving the unit, the
shipping materials MUST be reinstalled.
• Disconnect washer from electrical supply.
• While supporting the front access panel,
remove two screws from the bottom edge of
the panel.
• Gently lower the panel to remove it from the
washer.
• Place the shock sleeves on all four shock
absorbers. Refer to the illustration below.
• Insert hooked end of shipping brace into the
open slot of the motor mount.
• Attach the brace with the five bolts and
washers. Refer to the illustration below.
• Reinstall front access panel.
Refer to the INSTALLATION INSTRUCTIONS for
proper procedures whenever the washer is moved.
Shock
Sleeves
Motor
Mount
Hooked End of
Shipping Brace
Bolts and Lockwashers
FLW2043N
FLW2043N

Cleaning Foreign Object Trap

The washer's pump has a trap that may collect
foreign objects. The trap may need to be cleaned if
water is draining slower than usual. To clean:
• Disconnect washer from electrical supply.
• While supporting the front access panel,
remove two screws from the bottom edge of
the panel.
• Gently lower the panel to remove it from the
washer.
NOTE: The pump may have some water in it. Use
a rag or a container to catch water. If the wash
drum is full of water, use a wet/dry shop vacuum
to catch the water.
• With rag or vacuum ready, unscrew the black
cap on the left side of the pump and remove
trap.
• Clean the debris from the trap.
• Reinstall the trap and access panel.
• Reconnect washer to electrical supply.
-27-
801989