Installation; Before You Start; Tools; Parts Included - Speed Queen AFN50RSP113TW01 Installation Instructions Manual

Frontload washers
Hide thumbs Also See for AFN50RSP113TW01:
Table of Contents

Advertisement

Before You Start

Tools

For most installations, the basic tools you will need are:
3
7
1. Safety Glasses
2. Wood Block
3. Wrench
4. Screwdriver
5. Pliers
6. Socket Wrench
7. Gloves
8. Level
Figure 2
NOTE: If the washer is delivered on a cold day (below
freezing), or is stored in an unheated room or area dur-
ing the cold months, do not attempt to operate it until
the washer has had a chance to warm up.
NOTE: Install dryer before washer. This allows room
for attaching exhaust duct.
NOTE: Some moisture in the wash drum is normal. Wa-
ter is used during testing at the manufacturer.
NOTE: This appliance is suitable for use in countries
having a warm, damp climate.

Parts Included

An accessories bag has been shipped inside your washer. It in-
cludes:
Part No. 805470

Installation

1
2
4
5
6
8
FLW2376N_SVG
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Two fill hoses with washers and filter screens
Four rubber feet
Beaded strap
Installation Instructions
User's Guide
Warranty Bond

Order of Installation Steps

The proper order of steps must be followed to ensure correct in-
stallation. Refer to the list below when installing your unit.
1. Position washer near the installation area.
2. Remove the shipping materials.
3. Connect the fill hoses.
4. Connect the drain hose to the drain receptacle.
5. Position and level the washer.
6. Wipe out inside of the washer.
7. Plug in the washer.
8. Check installation.

Position Unit Near Installation Area

Move unit so that it is within 4 feet [1.2 meters] of the desired
area of installation.
NOTE: For best performance and to minimize vibration
or movement, install washer on a solid, sturdy and lev-
el floor. Some floors may need to be reinforced, espe-
cially on a second floor or over a basement. Do not in-
stall the washer on carpeting, soft tile, a platform or
other weakly supported structures.

Remove Shipping Materials

1. Remove two screws at bottom of front access panel. Rotate
bottom of panel out and remove panel.
Figure 3
Installation
FLW2378N_SVG
5

Advertisement

Table of Contents
loading

Table of Contents