Table of Contents
Advertisement
Maintenance
Reinstallation of Shipping Materials
To prevent damage while moving the washer, the
shipping materials MUST be reinstalled.
Disconnect washer from electrical supply.
●
While supporting the front access panel, remove
●
two screws from the bottom edge of the panel.
Gently lower the panel to remove it from the
●
washer.
Place the shock sleeves on all four shock
●
absorbers. Refer to Figure 30.
Insert hooked end of shipping brace into the open
●
slot of the motor mount. Refer to Figure 30.
Attach the brace with the five bolts and washers.
●
Refer to Figure 30.
Reinstall front access panel.
●
1
1
Shock Sleeves
2
Motor Mount
3
Hooked End of Shipping Brace
4
Bolts and Lockwashers
Figure 30
Refer to Installation section, step 6 for proper
procedures whenever the washer is moved.
26
2
3
FLW2124N
4
FLW2124N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Cleaning Foreign Object Trap
The washer's pump has a trap that may collect foreign
objects. The trap may need to be cleaned if water is
draining slower than usual. To clean:
Disconnect washer from electrical supply.
●
While supporting the front access panel, remove
●
two screws from the bottom edge of the panel.
Gently lower the panel to remove it from the
●
washer.
NOTE: The pump may have some water in it. Use a
rag or a container to catch water. If the wash drum
is full of water, use a wet/dry shop vacuum to catch
the water.
With rag or vacuum ready, unscrew the cap on
●
the left side of the pump and remove trap.
Clean the debris from the trap.
●
Reinstall the trap and access panel.
●
Reconnect washer to electrical supply.
●
802733
Hide quick links:
Advertisement
Table of Contents
