Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Speed Queen SF3JM
Summary of Contents for Speed Queen SF3JM
- Page 1 Frontload Washers Original Instructions Keep These Instructions for Future Reference. FLW1542C_SVG CAUTION: Read the instructions before using the machine. (If this machine changes ownership, this manual must accompany machine.) Part No. 805197ENR6 August 2018...
- Page 3 WARNING Failure to install, maintain, and/or operate this ma- chine according to the manufacturer's instructions may result in conditions which can produce bodily injury and/or property damage. W030 WARNING For your safety and to reduce the risk of fire or an explosion, do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
-
Page 4: Table Of Contents
Table of Contents Safety Information..................6 Explanation of Safety Messages............... 6 Important Safety Instructions................6 Dimensions and Specifications..............8 Installation................... 10 Before You Start................... 10 Tools......................10 Order of Installation Steps................10 Position Unit Near Installation Area............... 10 Remove Shipping Materials................10 Connect Fill Hoses.................. - Page 5 Lubrication....................23 Cold Weather Care..................23 Care of Your Washer..................23 Cleaning Glass Sealing Area..............23 Replacing Hoses..................23 Filter Screens.................... 23 Extended Non-Use..................23 Cleaning Foreign Object Trap..............23 Reinstallation of Shipping Materials............24 Troubleshooting..................25 Disposal of Unit..................27 Contact Information................28 Manufacturing Date..................
-
Page 6: Safety Information
Safety Information Safety Information Explanation of Safety Messages Important Safety Instructions Precautionary statements (“DANGER,” “WARNING,” and Save These Instructions “CAUTION”), followed by specific instructions, are found in this manual and on machine decals. These precautions are intended WARNING for the personal safety of the operator, user, servicer, and those maintaining the machine. - Page 7 Safety Information • Children less than three years should be kept away unless Always contact your dealer, distributor, service agent or the man- continuously supervised. ufacturer about any problems or conditions you do not under- stand. • Do not reach into the washer if the washtub or agitator, if ap- plicable, is moving.
-
Page 8: Dimensions And Specifications
Dimensions and Specifications Dimensions and Specifications The workstation average sound pressure level is 68.7 dBA. Models Equipped With Drain Hose FLW2333N_SVG 610 mm [24 in.] 1126 mm [44.34 in.] 813 mm [32 in.] 938 mm [36.94 in.] 371 mm [14.6 in.] 683 mm [26.875 in.] 52 mm [2.04 in.] 704 mm [27.73 in.]... - Page 9 Dimensions and Specifications Models With Gravity Drain FLW2334N_SVG 1. 38 mm [1.5 in.] Inside Diameter; 47 mm [1.86 in.] Outside Diameter 610 mm [24 in.] 1126 mm [44.34 in.] 813 mm [32 in.] 938 mm [36.94 in.] 371 mm [14.6 in.] 683 mm [26.875 in.] 107 mm [4.2 in.] 104 mm [4.1 in.]...
-
Page 10: Installation
Installation Installation NOTE: This appliance is suitable for use in countries Before You Start having a warm, damp climate. Tools Order of Installation Steps For most installations, the basic tools you will need are: The proper order of steps must be followed to ensure correct in- stallation. -
Page 11: Connect Fill Hoses
Installation FLW2297N_SVG1 Figure 4 FLW2378N_SVG 6. Insert two plugs included in accessories bag into rear shipping bolt holes. Figure 2 2. Remove two 9/16 inch bolts and washers holding shipping brace to weight. 3. Remove two 9/16 inch bolts and washers holding shipping brace to washer base and remove brace. -
Page 12: Water Supply Requirements
Installation Water Supply Requirements 1. Insert rubber washers and filter screens (from accessories bag) in water fill hose couplings (two hoses supplied with Water supply faucets must fit standard 19 mm [3/4 inch] female washer). The filter screen must be facing outward. garden hose couplings. -
Page 13: All Other Models
Installation 8. Continue tightening and rechecking until no leaks are found. Connecting Hoses 1. Insert rubber washers and filter screens (from accessories bag) in water fill hose couplings (two hoses supplied with COLD washer). The filter screen must be facing outward. Models Through Serial Nos. -
Page 14: Install Washer Electrical Cord
Installation NOTE: Refer to 7-14-190 conversion instructions for 6. Turn water on and check for leaks. 400 Volt, 3-Phase WYE, 4 wire plus earth, 9.8 Amp to 7. If leaks are found, retighten the hose couplings. 230 Volt, 3-Phase DELTA, 3 wire plus earth conversion 8. -
Page 15: Non-Gravity Drain Models - Connect Drain Hose To Drain Receptacle
Installation Non-Gravity Drain Models - Connect Terminal Block Wired For 400 Volt WYE As Viewed Through Rear Access Panel Drain Hose to Drain Receptacle Remove the drain hose from its shipping position on the rear of the washer by removing the shipping tape. IMPORTANT: Drain receptacle must be capable of han- dling a minimum of 35 mm [1-3/8 inch] outside diame- ter drain hose. -
Page 16: Gravity Drain Models - Connect Drain Outlet To Drain System
Installation the drain hose from dislodging from drain receptacle during use. 3. If hose does not fit securely in standpipe because it is too long: a. Remove hose clamp attaching it to washer. b. Cut hose to desired length. c. Reattach hose and hose clamp. FLW2339N_SVG FLW2338N_SVG 1. -
Page 17: Position And Level The Washer
Installation Position and Level the Washer WARNING Washers elevated above floor level must be anch- ored to that elevated surface, base or platform. The material used to elevate the washer should also be anchored to the floor to ensure that the washer will not walk or that the washer can not be physically pulled, tipped or slid from its installed position. -
Page 18: Electrical Requirements
Installation Machine Must Be Hard Wired WARNING The appliance must not be supplied through an ex- ternal switching device, such as a timer, or connec- ted to a circuit that is regularly switched on and off by a utility. W943 Electrical Requirements 400 Volt, 50 Hertz, 9.8 Amp NOTE: This washer is factory-wired for a 400 Volt elec-... -
Page 19: Check Installation
Installation WARNING Any disassembly requiring the use of tools must be performed by a suitably qualified service person. W299 Check Installation 1. Refer to Installer Checklist on the back cover of this manual and make sure that unit is installed correctly. 2. -
Page 20: Operation
Operation Operation Operation Instructions IMPORTANT: Prior to first wash, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside of washer. IMPORTANT: Remove all sharp objects from laundry to avoid tears and rips to items during normal machine operation. -
Page 21: Set Fabric Selector/Wash Temperature (°C)
Operation Set Soil Level Push Soil Level touchpads to select A, B or C. Light indicates se- lection. LIGHT FLW79R_SVG MEDIUM FLW80R_SVG HEAVY LIQUID BLEACH FLW81R_SVG Table 1 FLW2389N_SVG Insert Coins or Card 1. Main Wash Detergent Insert Coins, if Needed 2. -
Page 22: Start Washer
Operation DOOR DOOR is lit whenever the door is locked. The door can- not be opened when this light is on. START START flashes one second on and one second off when the full vend price has been satis- fied. IMPORTANT: If washer fails to operate properly after installation, make sure electrical service and water supply faucets are turned on. -
Page 23: Maintenance
Maintenance Maintenance User-Maintenance Instructions Replacing Hoses Hoses and other rubber parts deteriorate after extended use. Ho- Lubrication ses may develop cracks, blisters or material wear from the tem- All moving parts are sealed in a permanent supply of lubricant or perature and constant high pressure they are subjected to. -
Page 24: Reinstallation Of Shipping Materials
Maintenance FLW2297N_SVG 1. Shipping Bolt Assembly FLW2444N_SVG2 1. Pump Figure 23 Reinstallation of Shipping Materials To prevent damage while moving the unit, the shipping materials MUST be reinstalled. 1. Disconnect washer from electrical supply. 2. Remove two screws at bottom of front access panel. 3. -
Page 25: Troubleshooting
Troubleshooting Troubleshooting Try these troubleshooting tips before making a service call. They may save you time and money. Washer Symptom Possible Cause/Solution Won’t Fill • Make sure power cord is plugged all the way into the electrical outlet. • Check the laundry room fuse or circuit breaker. •... - Page 26 Troubleshooting Washer Symptom Possible Cause/Solution Water Leaks • Check that fill hoses are properly installed on the faucets and the washer’s water mix- ing valve. • Check the condition of the fill hoses. Replace fill hoses every five years. • Make sure drain receptacle is not clogged.
-
Page 27: Disposal Of Unit
Disposal of Unit Disposal of Unit This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Refer to Figure 24 . -
Page 28: Contact Information
Contact Information Contact Information If service is required, contact the nearest Factory Authorized Please include a copy of your bill of sale and any service receipts Service Center. you have. If you are unable to locate an authorized service center or are un- WARNING satisfied with the service performed on your unit, contact the source from which you purchased your unit. -
Page 29: Installer Checklist
Installer Checklist Installer Checklist Fast Track for Installing the Washer Position Washer Near Installation Area. Gravity Drain Models - Connect Drain Outlet to Drain System. CHECK CHECK FLW2339N_SVG1 Remove the Shipping Position and Level the Materials and Install Washer. Plugs. CHECK CHECK FLW2359N_SVG...
Need help?
Do you have a question about the SF3JM and is the answer not in the manual?
Questions and answers