Installation Instructions - BORETTI BIK-38 Operating Instructions Manual

Installation instructions

The installation comes under the exclusive res-
ponsibility of specialists.
The installer is held to respect the local legisla-
tion and standards.
How to fix the gasket:
The gasket supplied with the hob avoids all infil-
tration of liquids in the cabinet.
This installation has to be done carefully, in
conformity of the following drawing.
Fitting - installing:
• The cut out sizes are:
Reference Worktop cut-out (mm)
Width x Depth
BIK-38
• Ensure that there is a distance of 50 mm
between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat
protection. Ideally the hob should be instal-
led with plenty of space on either side. There
may be a wall at the rear and tall units or a
wall at one side. On the other side, however,
no unit or divider must stand higher than the
hob.
• The piece of furniture or the support in which
the hob is to be fitted, as well as the edges
of furniture, laminate coatings and the glue
used to fix them, must be able to resist tem-
peratures of up to 100 °C.
• The mural rods or edge must be heat-resi-
sting.
• Do not install the hob above a non ventilated
oven or dishwasher.
30
350 x 490
2 mm
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection sheet (3).
• Ensure a space under the bottom of the hob
casing of 20 mm to ensure a good air circu-
lation of the electronic device.
• If a drawer is placed under the hob, avoid
placing flammable objects in this drawer
(for example: sprays) or non heat-resistant
objects.
• To protect the cut out edge, apply a coat of
varnish or special sealant. Particular care
must be given to applying the adhesive joint
supplied with the hob to prevent any leakage
into the supporting furniture. This gasket
guarantees a correct seal when used in con-
junction with smooth work top surfaces.
• The safety gap between the hob and the coo-
ker hood placed above must respect the indi-
cations of the hood manufacturer. In case of
absence of instructions respect a distance
minimum of 760 mm.
• The connection cord should be free of (me-
chanical) constraints after installation, at
alltimes.
WARNING: Use only hob guards designed by
•
the manufacturer of the cooking appliance or
indicated by the manufacturer of the appliance
in the instructions for use as suitable or hob
guards incorporated in the appliance. The use
of inappropriate guards can cause accidents.