Installation Instructions - BORETTI BIK-65 Operating Instructions Manual

The control panel displays [ L ] :
• Refer to the chapter control panel locking
page.
The control panel displays [ U ] :
• Refer to the chapter "Keep warm".

Installation instructions

The installation comes under the exclusive res-
ponsibility of specialists.
The installer is held to respect the local legisla-
tion and standards.
How to fix the gasket:
The gasket supplied with the hob avoids all infil-
tration of liquids in the cabinet.
This installation has to be done carefully, in
conformity of the following drawing.
Fitting - installing:
• The cut out sizes are:
Reference Worktop cut-out (mm)
Width x Depth
BIK-65
BIK-78
• Ensure that there is a distance of 50 mm
between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat
protection. Ideally the hob should be instal-
led with plenty of space on either side. There
may be a wall at the rear and tall units or a
wall at one side. On the other side, however,
no unit or divider must stand higher than the
hob.
70
560 x 490
750 x 490
The control panel displays [ II ] :
• Refer to the chapter "Pause".
2 mm
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection sheet (3).
• The piece of furniture or the support in which
the hob is to be fitted, as well as the edges
of furniture, laminate coatings and the glue
used to fix them, must be able to resist tem-
peratures of up to 100 °C.
• The mural rods or edge must be heat-resi-
sting.
• Do not install the hob above a non ventilated
oven or dishwasher.