Electrical Connection - BORETTI BIK-38 Operating Instructions Manual

Electrical connection

• The installation of this appliance and the connection to the electrical network should be entrus-
ted only to an electrician perfectly to the fact of the normative regulations and which respects
them scrupulously.
• Protection against the parts under tension must be ensured after the building-in.
• The data of connection necessary are on the stickers place on the hob casing near the con-
nection box.
• The connection to the main must be made using an earthed plug or via an omnipolar circuit
breaking device with a contact opening of at least 3 mm.
• The electrical circuit must be separated from the network by adapted devices, for example:
circuit breakers, fuses or contactors.
•
If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated
in the fixed installation, in accordance with the installation regulations.
• The inlet hose must be positioned so that it does not touch any of the hot parts of the hob or
even.
Caution!
This appliance has only to be connected to a network 230 V~ 50 Hz.
Connect always the earth wire. Respect the connection diagram.
Use the connecting cable that is attached to the device.
The green / yellow wire correspond to the earth wire, the blue wire correspond neutral wire and
the brown wire correspond to the phase.
Mains
230V~1P+N 50Hz
* calculated with the simultaneous factor following standard EN 60 335-2-6
Caution!
Ensure that you correctly attach the wires and the bridges and tighten the screws properly.
Boretti cannot be held responsible for any incident resulting from incorrect connection
or which could arise from the use of an appliance which has not been earthed
Connection Cable diameter Cable
1 Phase + N 3 x 2,5 mm²
or has been equipped with a faulty earth connection.
Protection calibre
H 05 VV - F 16 A *
H 05 RR - F
D
EN
31