Related Manuals for Politec ALES WS
Summary of Contents for Politec ALES WS
- Page 1 PRODUCT ALES WS Product code ALES WS ALES WS INFRARED PERIMETER BARRIER WITH DOUBLE SELF-POWERED OPTICS INSTALLATION AND MOUNTING MANUAL VERSION 2.1...
-
Page 2: Table Of Contents
11. Receiver…………………….……………………….…………………………………..…………..…….………………....13 12. Barrier alignment …………………………………………………………………..………………………...……………… 14 12.1 Calibration using SMA system 12.2 Alignment test 13. Frequency selection…………………………………………………………………………..………………..……….…………17 14. Intervention time adjustment………………………..…………………………..……………………………...……..18 15. Technical specifications ………………………………………………………………………..……………..……………………… 18 16. FAQ ..............................19 17. Product disposal……………………………………………………………………………..………………………....……19 ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 3: Introduction
The system has been designed to detect intrusions and activate the alarm; it is not a device that prevents intrusion.Politec is not responsible for damage, injury or loss caused by accidents, theft, force majeure (including momentary lightning-induced overcurrent), abuse, improper or incorrect use, faulty installation or inadequate maintenance. -
Page 4: General Warnings
• Manufacturer's liability:Politec assumes no liability for failures resulting from incorrect installation; lack of maintenance, incorrect assembly or use. • Politec is also not liable for incorrect or incomplete operation of the product or failure to detect intrusion. •... -
Page 5: List Of Main Components
Battery 3.6 V 19 Ah Battery clip lock Adhesive Velcro for fixing radio Gasket transmitters inside the compartment Radio transmitter compartment Wall fixing plate Polycarbonate black cover U-shaped bracket for pole fixing ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 6: Preparation For Installation
• Check that the surface chosen for the installation of the product is sturdy so as to ensure stable fixing and that it is adequately protected against possible impacts or the elements. ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 7: Examples Of Mounting/Fixing
The ALES WS barrier can be installed on a wall, using the fixing plate, or on a pole, adding the U- shaped bracket ( 48-50 mm pole). -
Page 8: Placement And Installation Height
You must be careful not to alter the seals, plastics and mechanical parts of the product, and use the original accessories. In the case of repairs under warranty (2 years) but with evident signs of incorrect installation, Politec s.r.l. shall reserve the right to decide on any repair costs. - Page 9 ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1...
-
Page 10: Evaluations Before Installation
TX and RX, thereby ensuring a good amount of signal constantly, even in case of particular climatic conditions. ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 11: Barrier Positioning
DO NOT place barriers close to roads: vehicle lights directed towards the RX could create disturbances DO NOT place barriers near automatic gates: photocell signals can create interference ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 12: Connections And Description
9. Connections and description 9.1 Type of cable Use a SHIELDED type cable to make the connection between the radio transmitter and the Ales WS barrier.It is also necessary to connect the braid to the negative in the terminal board. -
Page 13: Receiver
5 TRIMMER To adjust the intervention time 6 TMP Spring-loaded TAMPER to protect against cover removal 7 LED INDICATOR Flashes when the power is connected 8 JUMPER (3V/3.6V) Power output selector for Radio Transmitter ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 14: Barrier Alignment
It is sufficient to apply the filter only on the TX, there is no need to repeat the operation also on the RX. ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 15: Alignment Test
The maximum alignment condition will be reached when the high-intensity LEDs are on steady and the buzzer will emit a continuous sound, for this reason, it may be necessary to make minor adjustments also on the RX optic. ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... - Page 16 TRANSMITTER optic with your hand: if the RECEIVER continues to give a continuous beep, it means that it sees another infrared source that must be turned off and eliminated. ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1...
-
Page 17: Frequency Selection
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 18: Intervention Time Adjustment
NC contacts (only on RX) Alarm and Tamper output The TX transmits Tamper to the RX via IR Operating temperature -25° (with heat.)+65° Ingress protection rating IP65 Pole/wall mounting accessories 2-YEAR FULL WARRANTY ALES WS POLITEC | INSTALLATION MANUAL - VER.2.1... -
Page 19: Faq
• For more precise alignment, position one side of the Ales WS cover in front of the lenses in order to have two surfaces interposed between TX and RX to double the attenuation of the beam;... - Page 20 For technical support, contact your security systems distributor...
Need help?
Do you have a question about the ALES WS and is the answer not in the manual?
Questions and answers