Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Politec ALES WS
Summary of Contents for Politec ALES WS
- Page 1 INFRARED BARRIER BATTERY POWERED DOUBLE BEAMS...
- Page 2 Do not install multiple beams where the transmitter beam can interfere with other receiver beams. It is always better place either transmitter or receivers back to back. Politec S.r.l. | Manual ALES WS – Ver. 1.0...
- Page 3 (RX) Vertical adjustment screw Lens Unit base Battery case Battery 3.6 V 19 Ah 10 Battery clip lock 11 Gasket compartment for radio transmitter 13 Mounting plate 14 IR cover Politec S.r.l. | Manual ALES WS – Ver. 1.0...
- Page 4 COVER MOUNTING PLATE “U” BRACKET FOR POLE MOUNTING VELCRO TAPE FOR RADIO TRANSMITTER Politec S.r.l. | Manual ALES WS – Ver. 1.0...
-
Page 5: Installation Tips
In case of repairs covered by warranty (2 years) but with obvious signs of improper installation, the Politec s.r.l. reserves the right to decide on any repair costs. - Page 6 Fix barrier to bracket tightening screw through After alignment procedure and function test hole under optical and proceed with alignment (pages 10-11), replace IR cover and tighten the of barrier; under placed screw. Politec S.r.l. | Manual ALES WS – Ver. 1.0...
-
Page 7: Transmitter Board
4. CONNECTIONS AND DESCRIPTIONS To connect radio transmitter to ALES WS main board use a screened cable, connecting also the cable screen to the GND on terminal board ► in case of missed connection of cable screen into GND, some disturbs could be injected into the system causing a bad operability of the product. -
Page 8: Receiver Board
TAMPER INPUT jumper 5 ALARM SENSITIVITY ADJUSTMENT (see page 9) 6 TMP Anti-removal cover tamper. 7 SIGNAL LED It blinks just at power connection. VOLTAGE CONFIGURATION FOR RADIO TRANSMITTER SUPPLING OUTPUT (3V/3,6V). Politec S.r.l. | Manual ALES WS – Ver. 1.0... -
Page 9: Frequency Selection
7. FREQUENCY SELECTION To compose barriers or dams with more than one pair of Ales WS, it is necessary to avoid interference assign a different channel to each of them. To do this you must turn ON dip switches on the desired channel on the mother board. -
Page 10: Alignment Test
DIP 6 on RX mother board. 5. WALK-TEST: When DIP 6 is set OFF (after calibration), for 60 second every beam interruption is associate with a LED flashing and a buzzer sound. Politec S.r.l. | Manual ALES WS – Ver. 1.0... -
Page 11: Technical Features
Current draw TX: 300μA RX:350μA Tamper output N.C. Relay output (on RX). Operating temperature -25° (with heaters) +65° IP protection IP65. Indoor/outdoor. Wall/pole/tower. Mounting brackets included for wall/pole TOTAL WARRANTY 2 YEARS Politec S.r.l. | Manual ALES WS – Ver. 1.0... - Page 12 If possible, increase the alarm delay up; Repeated false alarms o Make sure to have used a correct screened cable and linked screen to GND of ALES WS motherboard. Politec S.r.l. | Manual ALES WS – Ver. 1.0...
Need help?
Do you have a question about the ALES WS and is the answer not in the manual?
Questions and answers