Advertisement
Quick Links
LLB-26/CBS/24V/ADR
TECHNICAL CHARACTERISTICS
Mains voltage
Maximum power consumption
Light source intensity
Degrees of cover protection
Produced in accordance with
Operation temperature range
Relative humidity
Viewing distance
Construction materials
External dimensions
Typical weight
Guarantee
GENERAL
1. Operations for installation, maintainance or
t e s t i n g m u s t b e d o n e b y a u t h o r i z e d
personnel only.
2. The device, must be connected only to the
GR-8600 panel via its ADR line.
3. First set the address before installation. To
address the device see on page 5.
Manufacturer
Model Number
Voltage Range
Nominal Power
Connections
Temperature (tc)
The light source contained in this luminaire shall only be replaced by the manufacturer, or his
agent, or a similar qualified person.
NOTE! The light source is non-user replaceable.
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
Z: Central supply
1: Maintained
C: Including inhibiting mode
G: Internally illuminated safety sign
Page 1 from 5
ADDRESSABLE EDGE ILLUMINATION SIGN
EN 60598-1, EN 60598-2-22, ΕΝ 55015, ΕΝ 61547
Thank you for your trust in our products
Olympia Electronics - European manufacturer
LED MODULE CHARACTERISTICS
FOR GR-8600 CBS
(for LED MODULE Specifications see page 1)
15-30V DC
2.5W
300lm
IP 44
o
-30 to 50 C
up to 95%
26 m
Aluminum, ABS/PC, PC, Plexiglass
240x35x179mm
745 gr.
3 years
ADDRESS OPERATION
For address operations refer to the installation
manual of the panel. Please see manual of CBS
panel
GR-8600
luminaires that can be interconnected.
LLB-26/CBS/24V/ADR
Olympia Electronics S.A
2405185
13-14.5V DC
1.95W
Embedded on the main pcb
45 °C max. across the board
for
maximum
number
923026005_09_001
of
Advertisement
Related Manuals for olympia electronics LLB-26/CBS/24V/ADR
Summary of Contents for olympia electronics LLB-26/CBS/24V/ADR
- Page 1 Typical weight 745 gr. 3 years Guarantee Thank you for your trust in our products Olympia Electronics - European manufacturer GENERAL ADDRESS OPERATION 1. Operations for installation, maintainance or For address operations refer to the installation t e s t i n g m u s t b e d o n e b y a u t h o r i z e d manual of the panel.
-
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS (after the mains interruption) Screws Unfasten the two side cover screws and remove the plastic cap by sliding it gently. Install the gaskets and make holes at the center of each gasket by using a small screwdriver. Pass the round cable through the gaskets. -
Page 3: Mounting Methods
MOUNTING METHODS SURFACE MOUNTING ON A WALL (single side luminaire) 2 Mounting screws Bolt Place the included mounting screws in these holes of the plastic bracket Aluminum bracket Figure 1 Plastic bracket Figure 2. Side view Figure 3. Front view GENERAL!! Measure the distance of the mounting holes and after the drilling place on these spots the mounting plugs... -
Page 4: Alternative Mounting Methods
ALTERNATIVE MOUNTING METHODS FLAG MOUNTED ON A WALL (double side luminaire) A-1135 SET, ONLY FOR PROFILUX-26 (OPTIONAL AFTER REQUEST) HANGING INSTALLATION (double side luminaire) A-1136 SET (OPTIONAL AFTER REQUEST) INSTALLATION PICTOGRAMMS 2.Insert the pictogramm after removing 1.Unfasten the two screws of the luminaire. the protective film from the back side. -
Page 5: Warranty
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.