U-Line Refrigerator/Ice-Maker Combos User Manual page 22

User's Manual
Install the insert as follows:
Insert edges may be SHARP! Use care when installing.
1. Remove top hinge screw pin (large Phillips head, see Figure 28).
Hold door to keep it from falling.
2. Remove door, being careful not to scratch top of door on hinge.
3. Pull door gasket out of groove (top edge of door only). Start in the
middle and pull outward, moving toward the edge (see Figure 29).
This may take some force.
Figure 28
4. Remove two small screws
holding door handle. Slightly
separate door handle from
door (see Figure 30).
5. Pull handle up and off.
!
UL131
20
Figure 29
Figure 30
UL117
UL132