Makita GA7060 Technical Information page 7

5-1 Armature, Ball bearing 6301DDW/ 6200DDW, Small spiral bevel gear (cont.)
5-1-1 Disassembling (cont.)
Fig. 5-1-1-7
[7] Remove four 5x30
Tapping screws .
Fig. 5-1-1-8
[8] Remove Gear housing complete together with
Armature ass'y.
Armature ass'y
Gear housing complete
Fig. 5-1-1-10
[11] Pull out Armature ass'y.
Waste cloth
Armature ass'y
Fig. 5-1-1-11
[12] Remove Retaining ring R-42 with 1R005,then remove Flat washer 20.
1R005
Retaining ring R-42
Fig. 5-1-1-9
[9] Fit an offset wrench into M8 Hex nut and place the opposite end
to a workbench as the stopper.
While holding Gear housing complete and the wrench with a hand,
turn Armature ass'y in direction of red arrow to loosen M8 Hex
nut.
Note: Cover Armature ass'y with a waste cloth to prevent
[10] Remove the loosened M8 Hex nut, then pull out Small spiral
Armature ass'y
Already removed through the step [10] in Fig.5-1-1-9.)
Gear housing complete
Flat washer 20
7 / 25
scratch/damage.
bevel gear. (Refer to Fig.5-1-1-8.).
M8 Hex nut (Refer to Fig.5-1-1-8.)
Worktable Armature ass'y
The opposite end of Offset wrench
Waste cloth
Gear housing complete
Small spiral
bevel gear
M8 Hex nut
Retaining ring R-42
Flat washer 20