To Connect To The Amplifier/Processor Using The Phono To Phono Low Level Interconnect - REL Acoustics Q Series Operating Instructions Manual

To connect to the amplifier/processor using the phono to phono low level
interconnect
Sub Low Level
Input. (One phono
Only on Quake and Q108)
Two low level inputs are provided, 0dB and +12dB, One only on Quake and Q108 at +12dB
Connect as shown above. Although a twin phono to phono interconnect is supplied, only one core
need be used, either the red or the black. Plug one end into the sub/LFE output on the
amplifier/processor and the other end into the 0dB input (single input on Quake and Q108) on the sub
woofer.
On the models with two low level phono inputs, if the output is too low when using the 0dB input then
use the more sensitive +12 dB input.
The output level is adjusted using the control marked LO LEVEL
If the low level connection is to be made to left and right pre-amp outputs then a 12dB attenuator is
available to balance the 0dB and +12dB phono inputs. See below.
One Q108 not suitable for this type of connection. Two Q108 units would be required.
Sub Low Level
Input Attenuator
Supplied Phono to Phono Interconnect.
.
12dB
REL Acoustics 'Q' range User manual
To sub/LFE output of
Supplied phono to phono
interconnect
14
Amplifier/Processor