Controls And Connections- Q200E, Q201E, Q400E - REL Acoustics Q Series Operating Instructions Manual

CONTROLS AND CONNECTIONS- Q200E, Q201E, Q400E

~ 220-240 VAC 50-60 HZ
1
LO LEVEL input volume control. Adjust for output level when using LO LEVEL phono input.
2 HI LEVEL input volume control. Adjust for output level when using HI LEVEL Neutrik input.
Roll off control. Adjust to set the upper roll off frequency of the Sub Bass System.
3
MODE SWITCH. Used to set phase* and to bypass crossover for Low Level input**.
4
Position 1 / Line: 0 degrees phase, crossover engaged low level input
Position 2 / LFE: 0 degrees phase, crossover bypassed for low level input
Position 3 / Line: 180 degrees phase, crossover engaged for low level input
Position 4 / LFE: 180 degrees phase, crossover bypassed for low level input
*PHASE SELECTION AFFECTS BOTH HI AND LO LEVEL INPUTS
**Crossover is always engaged for Hi level input regardless of mode switch position.
0dB LO INPUT phono socket. Used to connect the Sub Bass System at low level to the sub/LFE
5
output of the amplifier/processor or left and right pre-amp outputs.
If Lo Level inputs are used to connect pre-amp right and left outputs then a 12dB attenuator is
available from REL to balance the two inputs.
Alternatively, a high quality Y-adaptor may be employed to connect at either input as system gain
characteristics demand.
+12dB LO INPUT phono socket . As 6 but a higher sensitivety. If LO LEVEL inputs are used
6
connected to pre-amp right and left outputs then a 12 dB attenuator is available from REL to
balance the two inputs.
Alternatively, a high quality Y-adaptor may be employed to connect at either input as system gain
characteristics demand.
UNBAL HI INPUT Neutrik Speakon socket. Used to connect the Sub Bass System at high level
7
to the main speaker output of amplifiers.
8
IEC Mains input socket
8
FUSE 2 A/T
CE
200 WATT MOSFET SUB-BASS SPEAKER SYSTEM
PROTECTED BY
REL ACOUSTICS LTD NORTH ROAD BRIDGEND
http://REL.net FAX: +44 (0) 1656 766093
REL Acoustics 'Q' range User manual
POWER
MAX
LO LEVEL
MIN
MAX
HI LEVEL
MIN
59HZ
106HZ
ROLLOFF 41HZ
26HZ
32HZ
1 MODE SELECTOR
SOURCE
2
1 LINE
MODE
3
2 LFE
3 LINE
4
4 LFE
LO LEVEL
0dB +12dB
HI LEVEL
R
Q200E
CF31 3TP UNITED KINGDOM
11
1
2
3
PHASE
4
0
0
180 deg
180 deg
5
6
7