Test - Bosch FSR Series Training Manual

Test

1. What does HDS mean?
2. What does the C mean in HDS7022C?
3. Where is the data plate located?
4. The display can be set for what languages?
5. What do three beeps mean?
6. Temperature settings are increased or decreased in what increments?
7. The broil element is described as a ___-pass element.
8. Can take-out containers be used in the warming drawer?
9. The warming drawer has how many settings?
10.What are the burner ratings for the LF burner on a dual-fuel and all-gas range?
11.The ALL ELECTRIC range requires what amperage circuit?
12.To convert the ALL GAS range from nat. gas to propane what needs to be changed and adjusted?
13.On the interface board, if voltages are correct and no display is present, what should you do?
14.Configuring a control board for a wrong model will result in what?
15.On the regulator, what do you need to check after installation or servicing of unit?
16.When removing the maintop of the electric or gas Slide-In-Range be sure to remove what screw?
17.Is the replacement of the door latch in an FSR3 or SIR a wire-for-wire connection?
18.How do you enter the Test or Service mode in an FSR?
19.How do you enter the Test or Service mode in an FSR3 or SIR?
Jan. 2008, Iss. 1
20.What does Fault Code F32 indicate?
81