Disassembly - Sir - Gas/Dual-Fuel Maintop; Disassembly - Sir - Gas/Df Maintop - Bosch FSR Series Training Manual

Disassembly – SIR – Gas/Dual-Fuel Maintop
It is necessary to remove the maintop to access the jet assemblies. The maintop is held down by ball
studs and one screw in the back. To remove the maintop:
1. Remove the rear screw
2. Lift the maintop off the ball studs (this may require a little effort).
Replace the maintop by placing it over the ball studs and applying enough pressure to set the maintop
in place. Replace the rear screw.
Jan. 2008, Iss. 1
Be sure all four screws for each
burner plate are in and fully
screwed-down to avoid losing
flame due to the blower drawing
primary air from area.
Screw part number - 422098
Ball studs
Rear Screw
51