Halogen Light Assembly; Lower Oven Door (Double Wall Oven Only); Removing/Reinstalling The Lower Oven Door - TurboChef Residential Single and Double Wall Oven Service Manual

Figure 5.4: Survey Meter Placement
NOTE: Th ere may be several places on the door
where this procedure needs to be done. If so, start
out with a fresh water load each time a new area is
measured, or if measurement of an area takes longer
than 60 seconds.
8. After each test is complete, open the oven door
and dispose of the hot water.

Halogen Light Assembly

Th e halogen light assembly consists of 2 lights that
are powered when the door is opened or when the
oven light switch is pressed (see page 2.1). When the
door is opened, the left side lock motor assembly's
N.C. light switches supply power from the 12 VDC
power supply to the lights. Likewise, if the oven light
switch (see page 2.1) is pressed, power is supplied to
the left and right halogen lights as well.
CAUTION: DO NOT touch the bulb with
bare fi ngers; rather, use gloves, cloth, or tissue
when handling the bulb. If the bulb is accidentally
touched, clean it with isopropyl alcohol before
applying power.
CAUTION: To avoid burns, ensure the oven
cavity has had adequate time to cool before
performing the below procedure.
To replace a bulb in the Speedcook oven,
1. Remove the halogen light cover using the tool
provided with kit RWD-3014.
2. Remove the bulb by gently pulling it out of the
socket.
3. Install the new bulb.
4. Reinstall the cover, using the tool provided with
kit RWD-3014 to tighten it.
Lower Oven Door (Double Wall
Oven Only)
Th is section contains information about the
following:

- Removing/reinstalling the lower oven door

- Halogen bulb replacement
For information on accessing and removing parts,
and for part numbers, see the Appendix.
Removing/Reinstalling the Lower Oven Door
To remove or reinstall the lower oven door, follow
the steps below.
CAUTION: DO NOT lift the oven door by
the handle. Lifting the oven door by the handle can
damage the oven door and cause it to misalign.
1. Ensure the lower oven has cooled below 160°F
(71°C).
2. To gain access to the right and left lower-hinge
pockets, remove the oven from the cabinet
approximately 7" (178 mm).
3. Open the door completely.
4. Pull both hinge locks forward.
5. Raise the door until the hinge locks prevent the
door from closing any further.
6. Hold the door by the sides and lift the door out
of the hinge pockets.
7. To install a new door, hold the door by the
sides and slide the door into the hinge pockets
in the same manner the door was removed.
8. Open the door completely.
9. Push both hinge locks back into their original
positions.
5.5