Component And Assembly Location, Swo; Removing The Oven - TurboChef Residential Single and Double Wall Oven Service Manual

Residential single and double wall ovens
Table of Contents

Advertisement

A.8
APPENDIX - REPLACING OVEN COMPONENTS

Component and Assembly Location, SWO

DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).

Removing the Oven

In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of
the Speedcook oven's outer trim, must be removed. Th e oven may be safely pulled away from the wall
approximately 11" (280 mm) to remove the front top cover, lower EC access panel, and the door switch
covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart
capable of supporting approximately 230 lbs. (105 kg.).
Item Description
Air Switch
Blower, Exhaust
Cover, Back, SWO
Door Skin, Replacement
Door, Speedcook Oven
Door, Speedcook Oven, Inner
Electrical Compartment, SWO
(see pages A.16-A.17)
Front Trim, SWO
(see pages A.10-A.11)
Handle, Speedcook Oven
Harness, Single
Oven, Speedcook, SWO
(see pages -A.25)
Thermostat, 270F, Open on Rise
Top Cover, Front
Top Cover, Rear
USB Port, Gen 2
Item Part # Hardware Description
102009
Screw, 4-40 x 5/8, PPH, SS
104190
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWS-9018
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-3004-X
None
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-3019-X
Cover, Hinge Pocket
Screw, #8-32 x 3/8, PPH, THD-Forming, PLT
RWD-3022
None
N/A
None
Screw, #8 x 3/8 PH MOD TRUSS CRES
N/A
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, #8 x 2.00 PH MOD TRUSS SS
RWD-9011
Bolt, Handle, Speedcook Oven
RWS-9002
None
N/A
None
104228
Screw, #6 x 1/2, PPHD, DRL-PT, SS
RWD-9356
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-9355
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
103193
Bracket, USB, Strap
Hardware Part Number(s)
101550 (x2)
101688 (x2)
101688 (x11)
None
101688 (x4)
RWD-9472 (x2)
104227 (x2)
None
None
101682 (x16)
101688 (x4)
104184 (x2)
RWD-9458 (x2)
None
None
101687 (x2)
101688 (x7)
101688 (x11)
101688 (x2)
RWS-9026

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tdo30Dwo gen 1DwoSwoDwo gen 2

Table of Contents