Upper Electrical Compartment, Dwo Gen 2 And Swo; Diff Erentiating Between Dwo Gen 1 And Dwo Gen - TurboChef Residential Single and Double Wall Oven Service Manual

Residential single and double wall ovens
Table of Contents

Advertisement

A.16 APPENDIX - REPLACING OVEN COMPONENTS

Upper Electrical Compartment, DWO Gen 2 and SWO

DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).
Diff erentiating Between DWO Gen 1 and DWO Gen 2
Use the serial number to tell if the oven being serviced is a DWO Gen 1 or DWO Gen 2 oven. To view the
serial number, open the Speedcook oven door and locate the serial plate (between the Speedcook oven door's
hinges). If the serial number's fi rst fi ve characters are "TDO2D" (or "TSO2D" for SWO models), the oven is a
Gen 2 oven. If the fi rst fi ve characters are NOT "TDO2D" (or "TSO2D"), the oven is a DWO Gen 1 oven.
If the oven being serviced is a DWO Gen 1 oven proceed to page A.14 for that model's upper electrical
compartment illustrations.
Item Description
Blower, Dual
Cable, Display, Upper
Cable, Interconnect, Relay Board
Controls Assembly, Gen 2
(see pages A.18-A.19)
Cooling Fan, EC, Upper
Cord, Power
Duct, Mag Cooling, LHS
Duct, Mag Cooling, RHS
EMI Filter
Harness, Clock, Gen 2
Harness, L.V., Upper Oven, Gen 2
Harness, Power, Motor Controller RWD-9559
Harness, Wire, Gen 2
Heater Cover Plate
High Limit Switch
Mag Air Diverter Assembly,
Gen 2 (see page A.20)
Magnetron
Relay/Power Assembly
(see page A.21)
Snubber, Electrical
Stirrer Motor, Gear
Stirrer Motor, Hub
Item Part # Hardware Description
104164
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-9438
None
RWD-9542
None
N/A
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
104114
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-9412
None
RWD-9374
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-9373
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
104211
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
RWD-9543
None
RWD-9540
None
None
RWD-9538
None
RWD-9156
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
102075
Bracket, Hi Limit
Screw, M4X 0.7 x 8, PPHD, INT Tooth, SS
N/A
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
104154
Nut, Hex Flanged, M5, Yellow Zinc
N/A
Screw, #8-32 x 5/8 LG, SEMS, PPHD, SS
RWD-9497
None
104174
Screw, M3 x 8mm LG, PPHD, S.S.
104175
None
Hardware Part Number(s)
101688 (x2)
None
None
101688 (x5)
101688 (x3)
None
101688 (x3)
101688 (x3)
101688 (x2)
None
None
None
None
101688 (x8)
101688 (x2)
RWD-9388
101672 (x2)
101688 (x2)
101001 (x4)
102926 (x2)
None
101668 (x2)
None

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tdo30Dwo gen 1DwoSwoDwo gen 2

Table of Contents