Cleaning; Troubleshooting - FANATEC CSL Elite F1 Set Manual

Clean only with a dry or slightly damp cloth. Using cleaning solutions may
damage your CSL Elite F1® Set.
The CSL Elite F1® Set must not be modified differently than described in this
manual. Endor® AG expressly prohibits analysis and utilization of the electron-
ics, hardware, software, and firmware contained in the controller. In case diffi-
culties occur in connection with utilization of the CSL Elite F1® Set, please use
the following guide for elimination of errors which is available in the Downloads
tab of the product page on www.fanatec.com.
If the CSL Elite F1® Set is not working properly:
Problem description
After firmware update of the CSL Elite F1® Set
the steering wheel is not properly centerd.
After firmware update of the CSL Elite F1® Set
the H-pattern shifter is not working properly.
The driver window does not show the attached
steering wheel.
45

CLEANING

9

TROUBLESHOOTING

10
Solution
After doing a firmware update on the CSL Elite
F1® Set the wheel center position must be man-
ually calibrated. See chapter 'CSL Racing Wheel
Functions' 'Firmware and driver update' of this
manual for more details.
After doing a firmware update on the CSL Elite
F1® Set the H-pattern shifter must be manually
calibrated. See chapter 'CSL Elite F1® Set
Functions' 'Firmware and driver update' of this
manual for more details.
Make sure that you have updated your CSL Elite
F1® Set to the latest firmware version which can
be downloaded from the Downloads section of
the Fanatec website www.fanatec.com.
Check the pins inside the quick release of
the steering wheel, these must not be bent or
damaged.
Try to use another steering wheel. If this is also
not detected the CSL Elite F1® Set might be
damaged.