FANATEC CSL Elite F1 Set Manual page 34

When the update is done the CSL
Elite Wheel Base + will restart
automatically after firmware update is
completely finished as shown on the
right-hand side:
The CSL Elite Wheel Base + switches
off and on automatically followed by
executing the calibration run.
IMPORTANT:
attached steering wheel while the
CSL Elite Wheel Base + restarts
and performs the initial calibration
run to avoid injuries and/or
miscalibration!
IMPORTANT:
driver to prevent the installation of wrong firmwares on the CSL Elite F1®
Set! Do not try to force installation of any wrong firmware to the CSL Elite
F1® Set to avoid damages.
IMPORTANT:
Elite Wheel Base + has to be manually calibrated again. This is also in-
dicated by the LED display of the steering wheel showing 'CAL'. This
message will disappear after manual calibration of the wheel center. See
chapter 'Hotkeys'
IMPORTANT:
to the CSL Elite Wheel Base +has to be manually calibrated again. See
chapter 'Hotkeys'
34
Do not touch the
The CSL Elite F1® Set is secured by firmware and by
After firmware update the center position of the CSL
'Wheel center calibration' for more details.
After firmware update the H-pattern shifter connected
'Shifter calibration mode' for more details.