Cleaning; Washing The Machine - Toro Workman Topdresser 1800 Operator's Manual

Figure 41
1. Brush motor
3. Slide brush into position at right side, and snug
the nuts.
4. Slide brush into position at left side, and snug
the nuts.
5. Insert a piece of stiff paper between the brush
and the conveyor belt.
The brush must be the same height from side
to side.
6. If the brush position is correct, tighten nuts.
If the brush position is not correct, repeat steps
1 through 6.

Cleaning

Washing the Machine

Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Do not use power-washing equipment
g012658
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. Avoid excessive use of water
near the control panel.
27