Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S); Pre-Maintenance Procedures - Toro Workman Topdresser 1800 Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.

Maintenance Safety

•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Shut off hydraulic control to the machine.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or assistance is desired, contact an
authorized Toro distributor.
•
Ensure that the machine is in safe operating
condition by keeping nuts, bolts, and screws tight.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Every 40 hours
Every 200 hours
Pre-Maintenance
Procedures

Preparing for Maintenance

1. Shut off the machine by doing the following:
•
239999999 and before, move the remote
hydraulic valve handle to the O
•
240000001 and up, move the hydraulic lift
lever to the O
2. Move the machine to a level surface.
3. Set the parking brake of the Workman vehicle,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's seat.
Maintenance Procedure
• Check the hydraulic lines and hoses.
• Check the brush position and wear.
• Lubricate all the grease fittings.
position.
FF
position.
FF
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Do not check or adjust the chain tension when the
vehicle engine is running.
•
Carefully release pressure from components with
stored energy.
•
Support the machine with jack stands whenever
you work under the machine.
•
After maintaining or adjusting the machine, ensure
that all guards are installed.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.

Lubrication

Grease Specification

No. 2 Lithium based grease
Greasing the Bearings and
Bushings
Service Interval: Every 200 hours/Yearly (whichever
comes first)
1. Perform the steps in
(page 20).
2. Lubricant each of the grease fitting described in
the grease-fitting table with the specified grease.
20
Preparing for Maintenance