Advertisement
Footswitch Upgrade Kit
For Multi-Pro 5600 Turf Sprayer
Model No. 110-5076
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
2
No parts required
Floor switch
Wiring harness
Hex-head screw (1/4 inch)
3
Lock washer (1/4 inch)
Nut (1/4 inch)
Wire tie
Step
1
Preparing the Machine
No Parts Required
Procedure
1. Park the sprayer on a flat surface, lower the
booms, set the parking brake, stop the engine,
and remove the key.
2. Disconnect battery negative cable.
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Step
Removing the Foot Switch
No Parts Required
Procedure
1. Disconnect Sprayer Foot Switch connector
2. Remove the retaining nut and remove the
3. Remove the bolt securing the left side of
Register at www.Toro.com.
Form No. 3354-831 Rev A
Installation Instructions
Qty.
–
Prepare the machine.
–
Remove the foot switch.
1
1
2
Install the oor switch.
2
2
4
2
under floor pan.
sprayer foot switch from the floor pan. Discard
the foot switch.
the front hood to the floor pan to allow the
existing floor switch wiring to be brought
above the floor pan (Figure 1).
Original Instructions (EN)
Use
Printed in the USA.
All Rights Reserved
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Toro 110-5076
Summary of Contents for Toro 110-5076
- Page 1 Form No. 3354-831 Rev A Footswitch Upgrade Kit For Multi-Pro 5600 Turf Sprayer Model No. 110-5076 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Step Description Qty. – No parts required Prepare the machine.
- Page 2 (1/4 inch) and two nuts (1/4 inch) provided in loose parts (Figure 2). Figure 1 1. Front hood, left side 3. Bolt 2. Floor pan 4. Existing oor switch wiring Figure 2 1. New oor switch 3. Lock washer (1/4 inch) 2.
- Page 3 6. Use wire ties to secure the relays and harness to the frame under the dash as shown in (Figure 7. Reconnect the battery. 8. Test for proper floor switch function.
Need help?
Do you have a question about the 110-5076 and is the answer not in the manual?
Questions and answers