Fluidwell B Series Quick Reference Manual

B-ALERT
Flowrate monitor / totalizer
Quick Reference Guide
B-Series - Basic with a capital B
More info: www.fluidwell.com
MORE INFORMATION
Downloads:
•
Detailed user-manual
•
EU Declaration of Conformity (DoC),
by scanning the QR-code:
or visit our website:
www.fluidwell.com/bseries.
Fluidwell bv
Voltaweg 23
5466 AZ Veghel - The
Netherlands
www.fluidwell.com
Doc: B-Alert_QRG_02.docx
This publication is subject to change without prior notice.
1. INTRODUCTION
The B-Series are intended for use in safe areas (ordinary locations)
and designed and constructed for measurement purposes in
industrial processes. A hazardous situation may occur if the B-
Series is not used for the purpose it was designed for or is used
incorrectly.
2. DESCRIPTION
The B-Alert is used as a flowrate monitor and indicator / totalizer
and has one flowmeter input and two alarm or scaled pulse outputs.
B-Series components:
• the front cover (3) with the display (5) and the control keys (4);
• the body (1) with knockouts for the cable glands (2).
3. OPERATION
SELECT-key
to view the Flowrate, Total, Accumulated total, alarm
value low and high flowrate.
CLEAR-key
when in the Total screen, to reset (clear) the Total.
Programming flowrate alarm value:
1. Press the SELECT key to view the ALARM screen.
2. Simultaneously, press SELECT + CLEAR.
3. Press SELECT to increase value and CLEAR to select digit.
4. Confirm change: simultaneously press SELECT + CLEAR
You can reset (clear) the Total:
1. Press the SELECT key to view the Total screen.
2. Press the CLEAR key two times.
Examples display information:
Flowrate Programming low flowrate alarm
4. NAVIGATION IN SETUP MENU
The setup menu has menus (e.g. 1, 2 and 3) and sub-menus
(e.g. 2.1, 2.2 etc.) to configure the B-Series.
Enter / leave setup: press and hold SELECT 7 seconds
Select a menu: press CLEAR
Select a sub-menu: press SELECT
Change selection:
➢
simultaneously, press SELECT + CLEAR.
➢
press SELECT to increase value en RESET to
select the digit or change the selection.
Confirm change: simultaneously press SELECT + CLEAR
5. SETUP MENU STRUCTURE
1. TOTAL 5.
1.1 Unit 5.1
1.2 Decimals 5.2
1.3 K-Factor 5.3
1.4 K-Factor decimals 5.4
5.5
2. RATE
2.1 Unit 6.
2.2 Time unit 6.1
2.3 Decimals 6.2
2.4 K-Factor 6.3
2.5 K-Factor decimals 6.4
2.6 Measurement 6.5
3. ALARM
3.1 Zero
3.2 Low alarm
3.3 High Alarm
4. METER
4.1 Signal
DIGITAL OUT
Output 1
output 2
Mode
Decimals
Amount
OTHER
Model
Software version
Serial number
Pin code
Backlight