Ethernet Cables; Appearance Of The Pgnd Cable; Technical Specifications Of The Pgnd Cable - Huawei ATN 905 Product Description

ATN 905 Multi-service Access Equipment
Product Description
Figure 4-11 Appearance of the PGND cable
Table 4-28 Technical specifications of the PGND cable
Cable Parameter
Electronic/electric cable-450 V/750 V-
H07Z-K-4 mm
smoke halogen-free fireproof cable

4.4.2 Ethernet Cables

On the ATN 905, Ethernet cables are used to input and output Ethernet service signals.
Ethernet cables are also referred to as network cables and can be classified into straight-through
cables and crossover cables according to the connection sequence of the copper cores in the
cables.
A network cable with a shield layer is a shielded cable and that without a shield layer is a non-
shielded cable.
The Ethernet service interfaces on the equipment are adaptive to the straight-through cables and
crossover cables. Hence, you can connect either type of the network cables to the Ethernet service
interfaces as required.
Ethernet cables need to be made on site.
Structure
Figure 4-12
Issue 01 (2013-05-30)
2
-yellow green-low-
NOTE
Based on the application scenarios, Ethernet cables are classified into two types: indoor Ethernet cables
and outdoor Ethernet cables. When outdoor ATN 905 devices are installed outdoors, the outdoor Ethernet
cables delivered with the devices must be used.
shows the appearance of the shield layer.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Terminal Parameter
Bare crimp terminal-OT-6mm
Circular pre-insulated terminal-12-10AWG-
Yellow
4 Hardware Structure
2
-Tin plating-
52