Pilot Air PAC Series Users Maintenance And Spare Parts Manual page 24

Support Menu
Oil hours
Oil filter hours
Air filter hours
Oil separator hours
Bearings lubric. hours : Indicates the hours remaining before the main electric motor bearing needs to be
Fan temperature
No load time
Stoppage time
Automatic start
Max start-up hours
Remote enabling
Fan extra time
Inverter
24 | P a g e
Start-Up and Operation
: Indicates the hours remaining before the oil needs to be changed.
: Indicates the hours remaining before the oil filter needs to be changed.
: Indicates the hours remaining before the air filter needs to be changed.
: Indicates the hours remaining before the oil separator filter needs to be changed.
lubricated.
: Defines the working temperature of the cooling fan. The threshold set has a hysteresis
that can be changed by 10°C. e.g. if the operating temperature is set at 80°C, the fan will
activate at 80°C and stop at 70°C (screw unit supply temperature).
: Defines the motor stoppage time from the moment the load solenoid valve was
deactivated because the desired pressure was reached.
: Defines the stoppage time of the compressor from the moment in which stoppage is
requested using the STOP(O) key. The solenoid valve is immediately deactivated.
: If the compressor is on, it starts automatically after an electricity cut. The first start should
be activated by pressing the START (I) key on the panel.
: Defines the maximum number of start-ups of the main electric motor within the arc of one
hour. If surpassed, the compressor will stay on (loaded or with no load depending on the
pressure) until the hour is up as calculated from first start-up and then returning to normal
functioning.
: Remote command enabling.
: Defines the time in which the cooling fan stays on after the working temperature of the
compressor has returned within the safety limits.
: Sub-menu for inverter configuration (see INVERTER MENU paragraph).
PLUS 56-75-Cod.197DD8805