Pilot Air PAC Series Users Maintenance And Spare Parts Manual page 23

Password
Certain menus are password protected. A password is requested if you try to access the reserved areas.
Removal of menu protection persists until you go back to the main screen.
Main Menu
User
Support
Factory
Alarms Log
Pressing "ENTER" on the highlighted alarm not only displays the type of alarm, but also the date, time, pressure
and the oil temperature in the instance in which the alarm occurred.
Info
User Menu
No load pressure
Loaded pressure
Pre. unit of measurement
Tem. unit of measurement : Defines the temperature unit of measurement.
Language
Display contrast
Display lighting
Time/Date setting
Start-up setting
23 | P a g e
Start-Up and Operation
: Menu containing the user parameters (see USER MENU paragraph).
: Menu containing the Support parameters (see SUPPORT MENU paragraph).
Password protected.
: Menu containing the Factory parameters (see FACTORY MENU paragraph).
Password protected.
: List of last alarms.
: Displays information on the board and firmware.
: Defines the pressure at which the compressor must run with no load. The maximum value
you can set is defined by the parameter "Maximum pressure" in the factory menu.
: Defines the pressure necessary to restart the compressor. The recommended value is
1.5 bar lower than that defined in the "No load pressure" parameter.
: Defines the pressure unit of measurement.
: Defines the language used in the menus.
: Defines the display contrast level.
: Defines the display backlighting level.
: Sets the date and time. Entry is guided and the procedure is only complete
when all the settings are saved.
: Sub-menu where you can define 10 programs (0-9) per week for compressor start-up
and stoppage. The parameters you can set are the start time, stoppage time, no load
pressure, loaded pressure and the day of the week. (see page 23)
PLUS 56-75-Cod.197DD8805