Installing The Heatsink; Removing The Ps2 And Serial Connector Board; Installing The Ps2 And Serial Connector Board - Dell OptiPlex 3020M Owner's Manual

b) Lift the heatsink away from the system board [2].

Installing the Heatsink

1. Place the heat sink on the system board.
2. Tighten the screws to secure the heatsink.
3. Install:
a) processor fan module
b) cover
4. Follow the procedures in

Removing the PS2 and Serial Connector Board

1. Follow the procedures in
2. Remove the cover.
3. Perform the following steps as shown in the illustration:
a) Disconnect the cable from the PS2 and serial connector board [1].
b) Remove the screws that secure the PS2 and serial connector board to the base panel [2].
c) Slide and lift the PS2 and serial connector board away from the computer [3].

Installing the PS2 and Serial Connector Board

1. Place the PS2 and serial connector board into its slot.
2. Tighten the screws that secure the PS2 and serial connector board to the base panel.
After Working Inside Your Computer.
Before Working Inside Your Computer.
Extracción e instalación de componentes 27