B.O.L.T BT4 User Manual page 35

B.O.L.T User Manual
B.O.L.T device switched ON, but
no LED is glowing
No response from the B.O.L.T
Device even after turning ON
B.O.L.T device switched on, but
not showing in List of the
available Bluetooth device in the
application
How is my health started in the
application but the device
doesn`t inflate the BP cuff
Spo2 probe not connected
IRT probe not connected
Bluetooth communication
disconnected while measuring
vitals and Bluetooth indicator
starts blinking
Application displays unexpected
errors/readings
© Copyright 2019, All Rights Reserved. AmZetta Technologies Private Ltd.
No charge in the
battery
Batteries are drained
Bluetooth pairing
problem
Bluetooth
communication error
Spo2 probe connection
error
IRT probe connection
error
Bluetooth
communication error
User is not followed the
mandatory procedures
Connect the respective
power adaptor to the
B.O.L.T device and charge.
Then power ON, if still the
LED is not glowing kindly
get it repaired in the
authorized service center
Charge the B.O.L.T device
Restart the B.O.L.T device,
Then try to connect again
Close the application.
Restart the B.O.L.T device
and restart the entire
process again
If "Connect Spo2 probe"
message pops up even if
the SPO2 probe is
connected to the device,
unplug the SPO2 probe and
re-plug the probe.
If "Connect Temperature
probe" message pops up
even if the Temperature
probe is connected to the
device, unplug the
temperature probe and re-
plug the probe.
Close the application.
Restart the B.O.L.T device
and restart the entire
process again
Follow the mandatory
procedures and retake the
readings
35