Caution - B.O.L.T BT4 User Manual

B.O.L.T User Manual
 The responsible organization and the user must verify the compatibility of the display
and SpO2 probe before use to avoid patient injury.
 This probe is only for use with the B.O.L.T device. Do not attempt to use this probe
with other medical devices.
 It is not recommended to operate the SpO2 probe greater than 41°C.
 No components made with natural rubber latex are used in the components that
come in patient tissue contact.
 The B.O.L.T device has been designed to pair with a single tablet/mobile phone during
patient monitoring activities. It is not possible to view patient data from multiple
tablets/mobile phones.
 Exposure to unsuitable environmental conditions may cause the device to
malfunction and provide inaccurate readings.
 If the user is uncertain about the accuracy of any measurement, it is the responsibility
of the user to verify the vital signs by an alternative means if deemed necessary and
make certain that the accessories and the device are functioning properly.
 Use of accessories, transducers, or cables with the B.O.L.T device other than those
specified may result in increased emissions or decreased immunity of the B.O.L.T
device.
 Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of
the B.O.L.T device including cables specified by the manufacturer. Otherwise,
degradation of the performance of this device may occur.
 To avoid measurement errors, avoid taking measurements near a strong
electromagnetic field radiated interference signal.
 Highly recommended for changing the battery of the base unit at the authorized
service center.

5.3 Caution

 Do not use the device while moving in a vehicle as this may result in erroneous
readings.
 Do not use the device in the Intensive and critical care unit in the hospital
environment.
 Do not use any other branded cuffs as this may result in inaccurate measurements.
 Do not use unauthorized parts and accessories for the measurement which may
result in inaccurate readings.
 Flashing of the red power LED indicates the critically low level of the battery.
 Do not store or use this device in locations which are maintained above the specified
temperature and humidity ranges.
© Copyright 2019, All Rights Reserved. AmZetta Technologies Private Ltd.
14