Operation - Husqvarna DT600 Operator's Manual

1. Press the left moss dethatcher (A) onto the left drive
shaft from the gear housing (E).
A
2. Fasten the moss dethatcher roller with split pin (B)
into the inner hole in the shaft.
A
3. Press the right moss dethatcher (C) onto the right
drive shaft from the gear housing (E).
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
1. Run the basic product warm and then shut down the
product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburettor, make sure that the
dethatcher is held against the ground and that no
one else is in the vicinity.
743 - 002 - 13.12.2019
B
C
B
C
C
E

Operation

4. Fasten the moss dethatcher roller with split pin (B)
into the inner hole in the shaft.
A
5. Mount the splash guard with the snap-on fasteners
(D).
Note: For assembling accessories on basic product,
refer to the manual of the basic product.
4. Keep the moss dethatcher idling.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Run the moss dethatcher at full gas (or nearly full
gas) with the wheels resting on the surface.
B
C
7