Operation - Husqvarna 325iRJ Operator's Manual

2. Turn the output shaft to align one of the holes in
the drive disc (B) with the related hole in the gear
housing.
3. Put the locking pin (C) in the hole to lock the shaft.
4. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft. (Fig. 37)
5. Make sure that the drive disc and support flange
engages correctly in the center hole of the grass
blade. (Fig. 28)
6. Attach the nut (G).
7. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm. (Fig. 38)
To remove the grass blade
1. Put the gear of the product on a flat surface to make
sure that the blade is removed correctly.
Introduction
WARNING:
safety chapter before you use the product.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 40)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
1858 - 005 - 05.10.2023

Operation

Read and understand the
Only use Husqvarna
If the battery does not
2. Put the locking pin (C) into the hole on the shaft to
lock the shaft.
3. Remove the nut (G).
4. Remove the support flange (F), the support cup (E)
and the grass blade (D) from the output shaft. (Fig.
37)
To install the suspension point
1. Install the suspension point between the arrows on
the rear handle and the loop handle. (Fig. 39)
Note:
Do not put the suspension point or the loop
handle on the decal.
2. Adjust the suspension point to make the product
balanced, and easy to use.
• Make sure that there are no cracks at the bottom of
the grass blade teeth or by the center hole of the
blade. Replace the blade if it is damaged.
(Fig. 41)
• Examine the support flange for cracks. Replace the
support flange if it is damaged.
(Fig. 42)
• Make sure that the locknut can not be removed
by hand. The locknut must have a locking force
of minimum 1.5Nm. Make sure that the tightening
torque is between 35-50 Nm.
(Fig. 43)
• Examine the cutting attachment guard for damages
or cracks. Replace the cutting attachment guard if it
has been hit or if it has cracks.
(Fig. 44)
• Examine the trimmer head for damages or cracks.
Replace the trimmer head if it has been hit or if it has
cracks.
Work position
• Hold the product with 2 hands.
• Hold the product on the right side of your body.
• Keep the cutting attachment below waist level.
• Always keep the product attached to the harness.
• Keep body parts away from the hot surfaces.
• Keep body parts away from the cutting attachment.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the suspension point.
17