Assembly - Husqvarna DT600 Operator's Manual

page 2 to find where these parts are located on your
attachment.
The life span of the attachment can be reduced and the
risk of accidents can increase if attachment
maintenance is not carried out correctly and if service
and/or repairs are not carried out professionally. If you
need further information please contact your nearest
servicing dealer.
WARNING: Never use an attachment with
defective safety components. The
attachment's safety equipment must be
inspected and maintained as described in
this section. If your attachment fails any of
these checks, contact your service agent to
get it repaired.
WARNING: All servicing and repair work on
the product requires special training. This is
especially true of the product's safety
equipment. If your product fails any of the
checks described below you must contact
your service agent. When you buy any of
our products we guarantee the availability of
professional repairs and service. If the
retailer who sells your product is not a
servicing dealer, ask him for the address of
your nearest service agent.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance.
To assemble the attachment
B
A
E
The arrow on the gear housing indicates the direction of
rotation. The gear housing is to be placed as illustrated.
IMPORTANT:
6
C
B
D
WARNING: Always stop the product before
you do maintenance on the attachment. Be
careful, the attachment can continue to
move after the power/throttle trigger is
released. Make sure that the attachment has
stopped fully. If you have a gasoline
operated product, disconnect the HT lead
from the spark plug. If you have a battery
operated product, remove the battery.
WARNING: Always use protective gloves.
• Check the entire product before starting. Check that
all guards and covers are complete and fastened
securely. Check all nuts and screws.
• If you have a gasoline operated product, check that
there are no fuel leaks.
• Replace damaged parts.

Assembly

The moss dethatcher rollers are marked with arrows
showing the direction of the rotation. Make sure the
moss dethatcher rollers are fitted correctly.
The moss dethatcher rollers must be fitted slightly
displaced in relation to each other. The moss dethatcher
springs should point in the same direction as the rotation
direction arrow shown on the gear housing.
743 - 002 - 13.12.2019