Operating Instructions: Electric - venture SPORT TREK Owner's Manual

3. Turn off propane supply. Wait five minutes for propane to clear
the area.
instructions, what to do if you smell propane. If you do not smell
propane, go to the next step.
4. Turn on the propane supply.
5. Turn on electrical power to the appliance.
Turn switch marked "Gas", which is located on bottom of the
6.
monitor panel, to on position. If the burner does not light, the
system will automatically attempt two more tries for ignition
before lock out. NOTE: Each ignition cycle will have a fifteen
second purge before spark cycle if the system is a three try
system.
7. If lock-out occurs before main burner lights, turn switch to off,
wait five seconds and turn switch to on position. This will restart
the ignition cycle. The first start-up of the heater may require
several ignition cycles before all air is purged from the propane
lines.
If the burner will still not come on, the following items should be checked
before calling a service person:
1. Switch turned off.
2. Propane supply to heater is empty or turned off.
3. Reset button on ECO is tripped.
4. If burner fails to light, call a Suburban Service Center or a local
RV Service agency.
Operating Instructions - Electric
Electric water heaters are designed to operate with a minimum amount
of service problems, however, proper operation and care is essential.
By far the most common trouble with electric water heaters results from
energizing the water heater before it is filled with water. Even brief
operation of the electric element without water in the tank will burn out the
electric heating element.
Before the electric element will operate, the switch located behind the
water heater door in the lower left corner of the control housing must be
If you smell propane, STOP! Follow previous
When the recreational vehicle is not in use or while traveling,
it is recommended that the propane supply also be turned off.
Before attempting to operate any water heater, you must be
sure the heater is FULL OF WATER. Failure to fill with water
will result in the tank warping and the element burning up.
When filling water heater with water, don't forget to open the
bypass valve to fill tank.
75