Propane Container; Servicing And Filling Propane Containers - venture SPORT TREK Owner's Manual

Propane Container

The propane cylinder is a D.O.T. approved
container to hold liquid propane under high
pressure, normally a 20 or 30 pound capacity.
The open/closing valve, referred to as an OPD
cylinder valve is to be closed at all times unless
hooked up to a propane system or when filling
the container.
Valve assembly actually has 3 valves in one
body.
1. Main pass thru portion to fill or draw propane is controlled by
upper 3 sided knob on top.
2. A small screw on the side of main body is referred to as a 10%
valve which allows air to escape when filling and indicates when
container has reached the 80% capacity.
3. Incoming positive seal valve MUST be pushed inward with fill
nozzle or POL fitting to draw vapor out for appliance use.
On the bottom/inside is the float which closes when 80% of capacity has
been reached. This permits expansion in tank when temperature rises.
See section on main hose.
At any point a container is disconnected, BE SURE to install the "dust
cap" over the acme valve (if so equipped).
Whenever the container is detached from the propane system, DO NOT
allow the cylinder to move or roll around during transportation to and from
the gas supplier.
A high pressure hose with an ACME fitting with POL fitting must be
completely and tightly installed before propane vapor can be withdrawn.

Servicing and Filling Propane Containers

Filling a propane container must be done carefully and correctly. Only a
qualified person, properly trained on inspection, filling, and safety
procedures, should fill containers.
A new container must be "purged" before placing into service and must
NEVER BE OVERFILLED. Purging is an operation performed by your
dealer or propane agency to remove any atmospheric air. As an owner
DO NOT use tools to open or close the tank valve. HAND
TIGHTEN ONLY to avoid damage to the valve or handle.
53
OPD Cylinder
Valve