venture SPORT TREK Owner's Manual page 55

Mounting and attaching instructions are listed below:
1. Thread the long rod into the base plate.
2. Set both bottles into base.
3. Drop the double hook bracket over the rod and hook onto the
bottle.
4. Attach the wing-nut to hold the bracket and tighten to hold the
bottle to the plate.
5. Attach the regulator with the vent down to the bracket.
6. Attach the main hose from the regulator to the manifold fitting in
the frame.
7. Attach two short pigtail hoses to the regulator and bottles at the
ACME fitting.
8. Test all propane connections for leakage.
A warning label has been located near the propane container.
1. Knob to open and close main
valve.
2. Complete valve assembly.
3. "10% valve", (small brass knob or
slot screw).
4. Container mounting stand.
ALL PROPANE LINES HAVE BEEN CHECKED WITH AIR
PRESSURE. DEALERS ARE REQUIRED TO RECHECK BEFORE
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE WITH
PROPANE ONLY. DO NOT CONNECT NATURAL GAS TO
Securely cap inlet when not connected for use. After turning
on gas, except after normal cylinder replacement, test gas
piping and connections to appliances for leakage with soapy
water or bubble solution. Do not use soap products that
contain ammonia or chlorine.
DELIVERY TO RETAIL CUSTOMERS.
All pilot lights, appliances, and their igniters (see operating
instructions) should be turned OFF before refueling of motor
fuel tanks and/or propane containers.
FAILURE TO COMPLY COULD RESULT IN DEATH OR
THIS SYSTEM.
2
3
VAPOR
LIQUID
SERIOUS INJURY.
55
1
20%
VAPOR
SPACE
4