Power For Operation; Trailer Set-Up Requirements-General - venture SPORT TREK Owner's Manual

Before operating the power slideout system in your coach, read and
become familiar with these instructions. Most of these components are
enclosed and can't be seen.
Always make sure the trailer is level before operating slideout
room.
Always make sure there is no obstructions blocking the path
of the room when it is moving.
Always make sure the path is clear of people and objects
before operating.
Always keep away from the slide rails under the coach when
room is in motion.

Power for Operation

All power slide systems operate on 12-volt DC power provided by a
converter. It requires 120-volt power and/or a 12-volt battery, fully
charged. A 12-volt distribution load center, breakers and fuses are
provided for each slide. Tow vehicle 12-volt power may also be used as
required.
Supplement your battery by either one of two choices:
1. Hook up a 120-volt AC power cord to recreational vehicle for
converter operation.
2. Use 12-volt power through the tow vehicle to the recreational
vehicle battery or batteries.
Either of these methods will help ensure maximum electrical power for
the slideout motor, as well as maintain your battery.
Battery is an aftermarket item, not supplied by manufacturer.
Trailer Set-up Requirements - General
Note:
1. Before operating the slideout room, level the trailer front to rear
and side to side.
2. Extend all stabilizer jacks to make solid contact with the ground
and/or on solid blocks. Placing stabilizer jacks onto a hard
surface allows the coach to remain square and assure a good
weather tight seal between the room and trailer sidewall.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
Stand clear of the room's interior path and verify that the
room's exterior path is clear before extending or retracting.
36